Test Scope For Specific Measures - Siemens Sinamics S120 Function Manual

Safety Integrated basic functions
9.10 Acceptance test and certificate
1. Extension of checksums (for each drive)
2. Countersignature
9.10.1.3

Test scope for specific measures

Scope of partial acceptance tests for specific measures
The measures and points specified in the table refer to the information given in
ChapterContent of the partial acceptance test.
Table 9- 8 Scope of partial acceptance tests for specific measures
Measure A) Documentation
Replacement of No
the encoder
system
Replacement of Yes, Points 1 and
an SMC/SME 2
Replacement of Yes, Points 1 and
a motor with 2
DRIVE-CLiQ
Replacement of Yes, Points 1 and
the Control Unit 2
/ power unit
hardware
Replacement of Yes, Points 1 and
the Power 2
Module or Safe
Brake Relay
Replacing the Yes, Points 1 and
TM54F 2
Firmware - Yes, only Point 2
upgrade(CU/po
wer unit/ Sensor
Modules)
Change to a Yes, Points 4 and
single 5.
parameter of a
safety function
(e.g. SLS limit)
Transfer of Yes
project data to
other machines
(series
commissioning)
490
B) Functional testing C) Functional testing
of safety functions of forced dormant error
detection
No No
No No
No No
No Yes, only Point 1
Yes, Points 1 or 2 Yes, only Point 1
and 3
Yes, but only testing Yes
of the selection of the
safety functions
Yes, if new safety Yes
functions are to be
used
Yes, test the No
appropriate function
Yes, but only testing Yes
of the selection of the
safety functions
D) Functional
testing of actual
value acquisition
Yes
Yes
Yes
Yes, only Point 1
Yes, only Point 1
Yes, only Point 1
Yes, only Point 1
Yes
Yes
Function Manual, (FH1), 01/2012, 6SL3097-4AB00-0BP2
E) Conclusion
of the report
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Drive functions