Test Scope For Specific Measures; A.3.1.3 Test Scope For Specific Measures - Siemens Sinamics S120 Function Manual

A.3.1.3 Test scope for s pecific measures
Sc ope of partial acceptance tests for specific measures
The measures and points specified in the table refer to the information given in Section
Content of the partial acceptance test (Page 405).
Table A- 1 Scope of partial acceptance tests for specific measures
Me asure A) D ocumentation B) Functional testing
R e placement of No
th e encoder
system
R e placement of Yes, Points 1 and
a n SMC/SME 2
R e placement of Yes, Points 1 and
a m otor with 2
D R IVE-CLiQ
R e placement of Yes, Points 1 and
th e following 2
h a rdware: Con-
tro l Unit, Motor
Mo dule, Power
Mo dule, or Safe
Bra ke Relay
R e placement of Yes, Points 1 and
th e TM54F 2
Fi rmware modi- Yes, only Point 2
fi cation (CU /
1)
p o wer unit /
Se nsor Mod-
u l es)
C h ange to a Yes, Points 4 and
si ngle parame- 5.
te r of a safety
fu n ction (e.g.
SL S limit)
Tra nsfer of Yes
p roject data to
o ther machines
(se ries commis-
si oning)
Oth er firmware Yes, only Point 2
ve rsion on
1)
Si motion D
Upgrading or downgrading
1)
Safety Integrated
Function Manual, (FHS), 07/2016, 6SL3097-4AR00-0BP6
C ) Functional testing
o f safety functions of forced dormant error
d e tection (test stop)
No No
No No
No No
Yes, Points 1 or 2 Yes, only Point 1
and 3
Yes, but only testing Yes
of the selection of the
safety functions
Yes, if new safety Yes
functions are to be
used
Yes, test the appro- No
priate function
Yes, but only testing Yes
of the selection of the
safety functions
Yes, if new safety Yes
functions are to be
used
A.3 Acceptance tests (recommendations)
D ) Functional
te sting of actual
va lue acquisition
Yes
Yes
Yes
Yes, only Point 1
Yes, only Point 1
Yes, only Point 1
Yes
Yes
Yes, only Point 1
Appendix
E) Conclusion
o f the report
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
407