Siemens Sinamics S120 Function Manual page 796

Appendix
A.2 Availability of SW functions
No.
4 Automatic restart for vector and Smart Line Modules 5/10 kW
5 The ability to mix servo and vector V/f control modes on one CU
6 Regulated V up to 480 V input voltage can be parameterized for
dc
Active Line Modules
7 Smart Mode for Active Line Modules booksize format
8 Extended setpoint channel can be activated
9 Evaluation, linear measuring systems
10 Synchronous motors 1FT6/1FK6/1FK7 with DRIVE-CLiQ resolver
Table A- 10 New functions, firmware 2.3
No.
1 Motor data set changeover (8 motor data sets)
2 Buffer for faults/alarms
3 Rotor/pole position identification
4 Booting with partial topology, parking axis/encoder, de-
activating/activating components
5 Friction characteristic with 10 points along the characteristic,
automatic characteristic plot
6 Utilization display
7 Evaluation of distance-coded zero marks for higher-level controls
8 Hanging/suspended axes/electronic weight equalization for higher-
level controls
9 SIMATIC S7 OPs can be directly coupled
10 PROFIBUS NAMUR standard telegrams
11 Parallel connection
12 Edge modulation
13 Servo control type
14 Terminal Module TM15 (DI/DO functionality)
15 1FN1, 1FN3 linear motors
16 1FW6 torque motors
17 1FE1 synchronous built-in motors
18 2SP1 synchronous spindles
19 1FU8 SIMOSYN Motors
20 1FS6 explosion-protected motors
21 SME20/25 external Sensor Modules for incremental and absolute
encoder evaluation
794
SW function
SW function
Servo Vector
- x
x x
x x
x x
x -
x -
x -
Servo Vector
x x
x x
x x
x x
x x
x x
x -
x -
x x
- x
- x
x x
x -
x x
x -
x -
x -
x -
x -
x -
x x
Function Manual, (FH1), 01/2012, 6SL3097-4AB00-0BP2
HW component
HW component
For chassis drive units
For chassis drive units
also chassis drive
units
Drive functions