Installing Glass - Kubota KX080-4 Workshop Manual

KX080-4, WSM

[3] INSTALLING GLASS

1. Completely eliminate all old adhesive on the frame of the cab.
2. Use the cleaner to clean the cab frame and the surface of the
new glass where adhesive will be applied to get rid of any dirt or
oil.
3. Affix the windshield dam to the surface of the new glass where
the adhesive will be applied.
4. Apply primer uniformly around the circumference of the
windshield dam.
5. Apply adhesive uniformly along the outer circumference of the
windshield dam.
6. Apply primer uniformly around the entire circumference of the
flange of the cab frame. (Application width: 18 mm (0.71 in.) or
more)
7. Make and install a spacer for in between the edge of the glass
and the cab's frame so that the glass does not slide down during
installation. (holds position and prevents slipping)
8. Press lightly all the way around the edge of the glass from the
outside, so the glass touches the shield dam and they stick
together.
9. Hold the glass in place with packing tape until the adhesive
hardens so the glass does not shift or come off.
(1) Glass
(2) Windshield Dam (W/Adhesive)
(3) Primer (Apply)
(4) Adhesive (Apply)
• For the front window
(1) Glass
(2) Windshield Dam (W/Adhesive)
(3) Adhesive (Apply)
(4) Fastener (Affix as Male/Female Set)
• Recommended shape of triangular bead
NOTE
• Cut the tip of the nozzle of the adhesive cartridge in the
shape of a V.
• Apply the adhesive to the glass so it forms a uniform
triangular bead.
(1) Nozzle Tip
(2) Windshield Dam (W/Adhesive)
(3) Adhesive (Apply)
5-S53
(a) At Least 7 mm (0.28 in.)
(b) At Least 12 mm (0.47 in.)
(c) 12 mm (0.47 in.)
(A) Start Affixing Dam Here
RY9212001CAS0087US0
(a) At Least 7 mm (0.28 in.)
(b) At Least 12 mm (0.47 in.)
(A) Line Up with the Edge of the
Frame
RY9212001CAS0088US0
(a) At Least 8 mm (0.31 in.)
(b) At Least 12 mm (0.47 in.)
RY9212001CAS0089US0
KiSC issued 08, 2015 A
CABIN