Kubota KX080-4 Workshop Manual page 73

KX080-4, WSM
2. Raise the track using a crane and mesh it with the sprocket.
(1) Sprocket
3. Operate the travel lever forward slowly and wind the track on.
When the track is sufficiently pulled on to where the track link
joint is at the front idler, lower the mini-excavator and place a
block under the track to support it.
(1) Front Idler
(2) Track
4. Mount tools a and b on the track plate and insert tool d from the
tool a side.
IMPORTANT
• Set tools c and g on tool b.
Align the holes of tools a and b with that of the master link
and then install.
(a) Tool a
(b) Tool b
(c) Tool c
5. Insert the master pin from the tool a side and use a hammer on
tool e to insert the master pin.
6. After tapping tool e in to the end, remove tools b and g.
IMPORTANT
• When removing tool g, be careful that the spring doesn't
make it go flying.
(1) Master pin
7. After remounting tool b, tap tool f with a hammer until the master
pin is all the way in.
(1) Master pin
1-S26
MACHINE BODY
RY9212148MBS0083US0
(3) Block
RY9212148MBS0084US0
(d) Tool d
(g) Tool g
RY9212148MBS0085US0
(b) Tool b
(d) Tool d
(e) Tool e
(g) Tool g
RY9212148MBS0086US0
(d) Tool d
(f) Tool f
RY9212148MBS0087US0
KiSC issued 08, 2015 A