Front Window; Adjusting The Closing Lock Of The Front Window (Top) - Kubota KX080-4 Workshop Manual

KX080-4, WSM

10. FRONT WINDOW

[1] ADJUSTING THE CLOSING LOCK OF THE FRONT WINDOW
(TOP)
When water leaks in the cabin or it rattles
1. Close the front window (top) and lock it securely.
2. Remove the trim on the top edge of the front window (top) about
half way along the frame and measure the clearance between
the glass and the cab frame.
NOTE
• If you remove the trim too far, the glass may shift out of
position, preventing a reliable measurement of the
clearance.
(1) Cab ASSY
(2) Front Window (Top)
(3) Trim
(4) Cab Frame
3. Remove the clip and then the lock cover.
(1) Lock Cover
4. Remove the lock of the front window (top) and loosen the lock's
mounting bolts.
5. Leave the rear bolt as is and lift up the front bolt 1.0 to 1.5 mm
(0.04 to 0.06 in.).
NOTE
• Lifting the bolt more than 1.5 mm (0.06 in.) may prevent the
lock from working.
6. Re-tighten the bolts to the specified torque.
7. Close the front window (top) and lock it securely.
8. Recheck the clearance between the glass and the cab frame
and make sure the clearance is smaller.
9. Operate the mini-excavator and make sure the rattling has
stopped while driving.
10. Spray some water on the window and make sure it does not
leak.
(1) Lock
(2) Bolt (Front)
5-S57
(a) Clearance
RY9212001CAS0091US0
(2) Clip
RY9212001CAS0092US0
(3) Bolt (Rear)
RY9212001CAS0093US0
KiSC issued 08, 2015 A
CABIN