Kubota KX080-4 Workshop Manual page 263

KX080-4, WSM
8. After inserting the disc and the camshaft, tighten the set screws.
• Tool to use: 4 mm hex socket
NOTE
• Wipe clean any excess thread lock compound from the set
screws.
• Apply a thread lock (Loctite 241) to the set screws.
Tightening torque Set screw
(1) Camshaft
9. Mount the lever on top of the disc and tighten the hex socket
bolts.
• Tool to use: 6 mm hex socket
Tightening torque Hex socket bolt
(1) Lever
10. Assemble the steel ball, the holder, washer 2 and the spring
inside the detent plug and test fit the lock nut and the adjusting
nut.
IMPORTANT
• Apply plenty of grease to the area around the steel ball.
(1) Detent plug
11. Install the detent plug in the cover and tighten.
12. Turn the adjusting plug to adjust the force required to release
the detent and tighten the lock nut.
• Tool to use: 22 mm socket
Tightening torque Detent plug lock nut
(1) Cover
(2) Detent plug
(3) Lock Nut
(4) Adjusting Nut
3-S104
HYDRAULIC SYSTEM
16.7 ± 1.0 N·m
1.7 ± 0.1 kgf·m
12.3 ± 0.7 lbf·ft
(2) Set Screw
RY9212158HYS0091US0
29.4 ± 2.0 N·m
3.0 ± 0.2 kgf·m
21.7 ± 1.5 lbf·ft
(2) Hex Socket Bolt
RY9212158HYS0092US0
RY9212158HYS0093US0
41.2 ± 2.9 N·m
4.2 ± 0.3 kgf·m
30.4 ± 2.1 lbf·ft
(a) 1.0 to 3.0 mm (0.04 to 0.12 in.)
RY9212158HYS0094US0
KiSC issued 08, 2015 A