Kubota KX080-4 Workshop Manual page 353

KX080-4, WSM
(C) (w/o attach) Start Point Set
• Make setting when the AUX1 proportional valve, spool and/or AUX1 knob is replaced.
• Use this setting method when an attachment is not available.
(D) Feeling Adj.
• Adjust the AUX1 start point to customer's specification.
[C] AUX2/Thumb Set
(A) Knob Set
• Set when the AUX2 knob is replaced.
1. Place the mini excavator on flat hard ground, lower the bucket
and the blade, and stop the engine.
2. Follow the chapter Releasing Pressure in the Hydraulic System
and release pressure in the hydraulic line.
3. Attach a pressure gauge at the end of the AUX1 discharge (high
pressure side, low pressure side).
4. Select Setting → AUX1 Set → (w/o attach) Start Point Set.
5. Follow the instructions on the meter panel.
6. Press SW5 to make the setting.
7. Follow the instructions on the meter panel and repeat steps 2
and 3.
[Work flow]
Accel to MAX → Measure L when pressure rises → Measure R
when pressure rises
1. Select Setting → AUX1 Set → Feeling Adj.
2. Follow the instructions on the meter panel and change the
number while monitoring the feel.
3. Press SW5 to make the setting.
CAUTION
• Only use if it does not work properly even after making the
start point setting.
(1) Right Fine Adjustment Value
1. Select Setting → AUX2/Thumb Set → Knob set.
2. Follow the instructions on the meter panel.
3. Press SW5 to make the setting.
4. Follow the instructions on the meter panel and repeat steps 2
and 3.
[Work flow]
AUX Knob R END → AUX Knob L END → Knob to Neutral
4-S22
ELECTRICAL SYSTEM
RY9212148ELS0036US0
(2) Left Fine Adjustment Value
RY9212148ELS0037US0
RY9212148ELS0038US0
KiSC issued 08, 2015 A