Kubota KX080-4 Workshop Manual page 219

KX080-4, WSM
4. Install the shaft and swash-plate in order.
(1) Shaft
5. Install plate B, the spring, plate A and the circlip in order inside
the cylinder block. Use a press to press on the inside of the
cylinder block and install the circlip.
• Tool to use: snap ring pliers
• Tool to use: Tool for pressing cylinder block
(1) Circlip
6. Install the three pins in the cylinder block and mount the retainer
holder.
IMPORTANT
• Apply grease to the pins.
• Apply hydraulic oil to the retainer holder.
(1) Pin
(2) Cylinder block
7. Install the piston ASSY into the retainer plate and then install it
into the cylinder block.
IMPORTANT
• Apply hydraulic oil to the pistons.
• Make sure the pistons move smoothly.
(1) Piston ASSY
8. Install the sub-assy of the cylinder block to the flange holder.
IMPORTANT
• Turn the assembly platform 1.6 rad (90°) to install them and
then turn it back afterwards.
(1) Cylinder block sub-assembly
3-S60
HYDRAULIC SYSTEM
(2) Swash-plate
RY9212158HYS0016US0
(d) Tool for pressing cylinder block
RY9212158HYS0017US0
(3) Retainer holder
RY9212158HYS0055US0
(2) Retainer plate
RY9212158HYS0018US0
RY9212158HYS0019US0
KiSC issued 08, 2015 A