Kubota KX080-4 Workshop Manual page 256

KX080-4, WSM
15. Install the hex socket bolt.
Tightening torque Hex socket bolt
• Tool to use: hex socket 3 mm
16. Apply grease to the ends of the pushrods.
IMPORTANT
• Use a soft spatula to apply the grease so you don't scratch
the surfaces of the pushrods or the plugs.
(1) Pushrod
17. After fitting the top of the bellows onto the cam, fit the bottom
edge into the groove in the cover.
IMPORTANT
• Before fitting the bottom edge of the bellows into the
groove of the cover, apply an anti-rust oil to the parts inside
the bellows.
(1) Bellows
3-S97
HYDRAULIC SYSTEM
6.9 ± 1.0 N·m
0.7 ± 0.1 kgf·m
5.1 ± 0.7 lbf·ft
RY9212148HYS0199US0
(2) Cam
RY9212148HYS0200US0
(2) Cover
RY9212148HYS0201US0
KiSC issued 08, 2015 A