Kubota KX080-4 Workshop Manual page 512

KX080-4, WSM
How to apply primer on the cab side
1. Remove dirt and grease on the opening surface of the glass
sash's flange with a cleaner such as white gasoline. Avoid using
an alcoholic cleaner.
2. Apply body primer evenly all around of flange from the end.
NOTE
• You have to finish the glass installation within 3 min. to
6 hours after coating the primer.
(1) Primer (Apply)
How to install the glass spacer
1. Remove dirt and grease on the surface of glass spacer with a
cleaner such as white gasoline.
2. Apply the primer to the glass spacer.
3. Install the glass spacer in the glass sash. (4 spots)
(1) Glass Spacer
How to install the sealant dam and apply the primer
1. Remove dirt and grease on the surface of the circumference at
the back of the sash glass to apply an adhesive agent and on
the surface of applying a sealant dam with a cleaner such as
white gasoline. Avoid using an alcoholic cleaner.
2. Put a sealant dam on the position as shown in the figure and
evenly apply the primer peripherally.
[ How to apply adhesive ]
1. Apply the adhesive along the circumference of the sealant dam.
NOTE
• You have to finish the glass installation within 3 min. to
6 hours after coating the primer.
• In order to keep water-tightness, the adhesive must be
applied unbrokenly.
• Installation of glass needs to be done within 3 min. after the
adhesive is applied.
(1) Sealant Dam (W/Adhesive)
(2) Primer (Apply)
(3) Adhesive (Apply)
5-S55
(a) 18 mm (0.71 in.) or more
RY9212032CAS0014US0
(a) 100 mm (3.9 in.)
(b) Cross Section of the Spacer
(c) Install in the Sash
(d) Inclined Surface
(e) Cab Side
RY9212032CAS0015US0
(a) 12 mm (0.47 in.)
(b) 12 mm (0.47 in.) or more
(c) 7 mm (0.27 in.) or more
(A) Starting Point of Installation
RY9212032CAS0016US0
KiSC issued 08, 2015 A
CABIN