Kubota KX080-4 Workshop Manual page 224

KX080-4, WSM
8. Drill a hole midway between the ring nut and the flange holder
and install a parallel pin.
• Tool to use: 6 mm drill bit
IMPORTANT
• Be sure to cover the screw holes with adhesive tape or the
like prior to drilling the hole.
• Completely remove all the debris from drilling the hole.
[NOTE]
Hole diameter: 6.00 to 6.15mm (0.236 to 0.242 in.)
Depth: 7.5 to 8.0 mm (0.30 to 0.31 in.)
(1) Adhesive tape
9. Install the thrust washer and bolt.
IMPORTANT
• Apply a thread lock (ThreeBond 2403).
• Clean screw holes prior to installation.
Tightening torque Bolt
• Tool to use: Torx T40
(1) Thrust washer
(2) Washer
10. Install the collar, needle bearing and planetary gear A in order.
(1) Collar
(2) Needle bearing
11. Install the sun gear and plate in order.
IMPORTANT
• Clean screw holes prior to installation.
• Apply a thread lock (ThreeBond 2403).
Tightening torque Bolt
• Tool to use: Torx T40
(1) Sun gear
(2) Plate
3-S65
HYDRAULIC SYSTEM
(2) Vacuum pump
RY9212158HYS0062US0
35.3 ± 2.0 N·m
3.6 ± 0.2 kgf·m
26.0 ± 1.5 lbf·ft
(3) Bolt
RY9212158HYS0063US0
(3) Planetary gear A
RY9212158HYS0028US0
35.3 ± 2.0 N·m
3.6 ± 0.2 kgf·m
26.0 ± 1.5 lbf·ft
(3) Bolt
RY9212158HYS0064US0
KiSC issued 08, 2015 A