Kubota KX080-4 Workshop Manual page 217

Hide thumbs Also See for KX080-4:

Table of Contents

KX080-4, WSM

10. Turn the assembly stand 1.6 rad (90°) and remove the cylinder

block sub-assembly, swash-plate and shaft in order.

(1) Cylinder block sub-assembly

(2) Swash-plate

11. Use a press to press Plate A down inside the cylinder block and

then remove the circlip. Remove the cylinder block from the

press and remove Plate A, the springs and Plate B.

• Tool to use: snap ring pliers

• Tool to use: Tool for pressing cylinder block

12. Turn the assembly platform back as it was and remove the

2-speed piston, springs and balls.

(1) 2-speed piston

13. Remove the oil seal.

• Tool to use: slotted screwdriver and hammer

• When you removed the shaft, if the ball bearing had not

been removed, remove them together now.

HYDRAULIC SYSTEM

RY9212158HYS0052US0

(d) Tool for pressing cylinder block

RY9212158HYS0013US0

RY9212158HYS0053US0

RY9212158HYS0014US0

KiSC issued 08, 2015 A

Chapters

Table of Contents