Kubota KX080-4 Workshop Manual page 401

KX080-4, WSM
2. Continuity check
[Measurement Conditions]
1. Key switch: OFF
2. Disconnect the connector to be tested.
3. Test the continuity based on the table below.
Mea-
sure- Connector Name (+ terminal side)
ment
(1) 2-speed switch
(2) 2-speed switch
(3) Main ECU
(4) Main (solenoid)
Regular: Continuity
Irregular: No continuity
[D] Testing the Equipment Itself
[E] Steps to Take after Completing Repairs
Pin No. Connector Name (- terminal side)
<2> Main ECU
<1> Main ECU
<81> Engine (solenoid)
<4> 2-speed solenoid
1. Testing the 2-speed switch
[Test Conditions]
1. Key switch: OFF
2. Disconnect the 2-speed switch connector from the machine and
press the switch and check for continuity.
Regular: Continuity
Irregular: No continuity
(a) 2-speed switch
2. Testing the 2-speed solenoid
[Test Conditions]
1. Key switch : OFF
2. Disconnect 2-speed solenoid connector from the machine and
test the solenoid separately.
2-speed solenoid Factory specification
(a) 2-Speed Solenoid Terminals
1. Delete failure record
1. While in the service/dealer mode, select Delete Fail Record and
delete the record.
2. After deleting the record, start the engine again and check to
make sure the warning is not shown on the meter panel.
(1) No Fail Record
4-S70
ELECTRICAL SYSTEM
Pin No.
<57>
<41>
<4>
<1>
RY9212148ELS0160US0
A : Angle Specification
B : Standard Specification
RY9212148ELS0100US0
12 Ω ±10 %
RY9212148ELS0101US0
RY9212148ELS0148US0
KiSC issued 08, 2015 A