Kubota KX080-4 Workshop Manual page 147

KX080-4, WSM
3. Pre-detent operation
Pre-detent is activated at a specified operating
angle. When steel ball (2) in the stepped section of the
disc (1) passes the step, operating torque increases
owing to compression of the spring (3). Due to this
change in operating torque, the operator knows he is
close to the actuation angle of detent operation at a
predetermined actuation angle.
(1) Disc
(2) Steel Ball
(3) Spring
4. When detent is activated
At the detent operation activation angle before the
end of stroke, the steel ball (1) slides into the V-shaped
groove of the disc (2), which is detent operation status.
If the operator releases the lever during detent
operation, the lever control angle is maintained and a
fixed secondary pressure continues to be applied.
(1) Steel Ball
(2) Disc
5. When detent is released
Detent can be released manually by applying a force
greater than the release torque to the operating lever in
the direction of neutral.
3-M51
HYDRAULIC SYSTEM
(a) Port 1
(b) Port 2
(P) Port P
(T) Port T
RY9212158HYM0007US0
(a) Port 1
(b) Port 2
(P) Port P
(T) Port T
RY9212158HYM0008US0
RY9212050HYM0022US0
KiSC issued 08, 2015 A