Kubota KX080-4 Workshop Manual page 236

KX080-4, WSM
7. Install the plug on the pushrod.
IMPORTANT
• Apply hydraulic oil to the pushrod.
(1) Pushrod
(2) Plug
8. Install the plug ASSY into the case.
If the return spring is too stiff, use the plate to install the ASSY.
IMPORTANT
• Be careful not to scratch the hole of the casing by prying
on the spool.
• Take care so the plug ASSY does not go flying.
9. Install the plate.
(1) Plate
10. Install the U-joint.
Tightening torque U-joint
• Tool (a): U-joint clamping tool
11. Install the round plate nut on the U-joint.
Tighten it until it touches all four pushrods equally.
CAUTION
• If you tighten it too far, the mechanism will not function
properly when the lever is in neutral, so be careful to adjust
the round plate nut to the correct position.
IMPORTANT
• Apply Loctite 262 to the top threads of the U-joint.
(1) Round Plate Nut
3-S77
HYDRAULIC SYSTEM
(3) O-Ring
RY9212148HYS0165US0
RY9212001HYS0494US0
RY9212148HYS0166US0
47.0 ± 3.0 N·m
4.8 ± 0.3 kgf·m
35.0 ± 2.0 lbf·ft
RY9212148HYS0167US0
RY9212148HYS0168US0
KiSC issued 08, 2015 A