Kubota KX080-4 Workshop Manual page 35

KX080-4, WSM
• Hold the connectors when separating them.
• Do not pull on the wire harness to separate the connectors.
(A) Correct
Pull on the harness from the connector and make sure the
harness does not come off. (Pull with 3 kgf (30 N, 7 lbf) or less of
force)
(A) Pull
• Straighten bent prongs and make sure none are sticking out or
missing.
• Remove corrosion from terminals with sandpaper.
(1) Missing Terminal
(2) Bent Prong
• Do not touch the terminals of connectors with bare hands.
(A) Do not touch
• Female connectors must not be spread too far open
(A) Correct
G-14
GENERAL
(B) Incorrect
RY9212001GEG0034US0
(B) Loosened Crimping
RY9212038ELS0011US0
(3) Sandpaper
(4) Corrosion
RY9212001GEG0035US0
RY9212038ELS0012US0
(B) Incorrect
RY9212001GEG0036US0
KiSC issued 08, 2015 A