Kubota KX080-4 Workshop Manual page 386

KX080-4, WSM
2. Continuity check
[Measurement Conditions]
1. Key switch: OFF
2. Disconnect the connector to be tested.
3. Test the continuity based on the table below.
Mea-
sure- Connector Name (+ terminal side)
ment
(1) Engine oil pressure switch
(2) Engine (solenoid)
Regular: Continuity
Irregular: No continuity
[D] Testing the Equipment Itself
[E] Steps to Take after Completing Repairs
Pin No. Connector Name (- terminal side)
<1> Main (solenoid)
<3> Meter panel
1. Measuring engine pressure
[Measurement Conditions]
1. Remove the engine oil switch, attach a pressure gauge and
measure the pressure.
At idle
Engine Oil Pressure
At Rated
RPM
Oil switch tapering screw
Tightening torque
R1/8
1. Delete failure record
1. While in the service/dealer mode, select Delete Fail Record and
delete the record.
2. After deleting the record, start the engine again and check to
make sure the warning is not shown on the meter panel.
(1) No Fail Record
4-S55
ELECTRICAL SYSTEM
Pin No.
RY9212148ELS0147US0
50 kPa
Usage
2
0.51 kgf/cm
limit
7.25 psi
Factory 200 to 390 kPa
specifica- 2.04 to 3.98 kgf/cm
tion 29.01 to 56.56 psi
150 kPa
Usage
2
1.53 kgf/cm
limit
21.76 psi
15 to 19 N·m
1.5 to 1.9 kgf·m
11.1 to 14.0 lbf·ft
RY9212148ELS0077US0
RY9212148ELS0148US0
KiSC issued 08, 2015 A
<3>
<9>
2