KX080-4, WSM
(3) Other Screens
No.
Screen display
1
2
3
4
5
6
7
8
9
10
Pressing SW4
–
–
–
The setup item is
displayed.
–
–
–
–
–
–
Message in fail record
Switch 2 (crane) pressed on machine w/o
–
overload warning
When meter or ECU replaced without doing
–
setup
During setup after changing the meter or the
–
ECU, this screen comes up to confirm the
meter has been changed.
When neither the meter nor the ECU have
–
been replaced, but some setting needs to be
made.
If you attempt to start the engine with the lever
–
lock still down.
If you press switch 3 (AUX) with the lever lock
–
still up.
If you turned the key OFF but fail to take it out
–
(Anti-theft spec. only)
–
–
If you press the multipurpose switch before
–
registering it.
4-S38
ELECTRICAL SYSTEM
Reason detected/steps to take
• If you press switch 3 (AUX) on a machine
w/o AUX1/AUX2/thumb spec.
• If you setup the model as AUX1 (w/o) and
press switch 3 (AUX).
• If you press the AI switch on a machine w/o
the AI spec.
• If you set up the model as AI (w/o) spec.
and press the AI switch.
KiSC issued 08, 2015 A