Kubota KX080-4 Workshop Manual page 191

KX080-4, WSM
12. Remove the shaft. Remove the hex socket bolts and then the
housing.
• Tool to use: 12 mm hex socket
(1) Shaft
(2) Hex socket bolt
13. Remove the plate.
(1) Plate
14. Remove the driver gear, planetary gear A, needle bearing, inner
race and washer and then remove the flange holder.
(1) Drive gear
(2) Planetary gear A
(3) Needle bearing
15. Remove the sun gear, hex flange holder and then the plate.
• Tool to use: 5 mm hex socket
CAUTION
• If the bolts are tight and you can't loosen them, heat them
with a heat gun or the like.
• Always use a tap to clean the threads of any thread lock on
them..
(1) Sun gear
(2) Hex flange bolt
16. Remove planetary gear B, needle bearing, inner race and
washer and then remove the flange holder.
(1) Planetary gear B
(2) Needle bearing
(3) Inner race
3-S32
HYDRAULIC SYSTEM
(3) Housing
RY9212148HYS0108US0
RY9212148HYS0109US0
(4) Inner race
(5) Washer
(6) Flange holder
RY9212148HYS0110US0
(3) Plate
RY9212148HYS0111US0
(4) Washer
(5) Flange holder
RY9212148HYS0112US0
KiSC issued 08, 2015 A