Kubota KX080-4 Workshop Manual page 246

KX080-4, WSM
7. Install the pushrod into the plug.
8. Install the seat on the pushrod.
IMPORTANT
• Apply hydraulic oil to the pushrod prior to assembly.
• Install it in the same position as before disassembly.
(1) Plug
(2) Pushrod
9. Install the spring seat and damping springs into the casing.
IMPORTANT
• Install them in the same position as before disassembly.
• Make sure the springs don't get tangled with each other.
(1) Spring seat
(2) Damping spring, small
10. Install the pushrod ASSY into the casing.
(1) Pushrod ASSY
11. Use special tool (a) to insert the bushing into the cover.
• Tool to use: hammer
IMPORTANT
• Take care so the bushing doesn't protrude inside the cover.
(1) Cover
(2) Bushing
12. Mount the cover with hex socket bolts.
• Tool to use: torque wrench
IMPORTANT
• Tighten the hex socket bolts alternately so the cover stays
level during assembly.
Tightening torque Hex socket bolt
3-S87
HYDRAULIC SYSTEM
(3) Seat
RY9212148HYS0257US0
(3) Damping spring, large
RY9212148HYS0258US0
RY9212148HYS0259US0
(a) Special tool
RY9212148HYS0260US0
39.8 ± 4.0 N·m
4.1 ± 0.4 kgf·m
29.4 ± 3.0 lbf·ft
RY9212148HYS0261US0
KiSC issued 08, 2015 A