Kubota KX080-4 Workshop Manual page 197

KX080-4, WSM
Brake piston hole alignment positions
Install so the pin hole is at position .
(a) 0.393 rad (22.5 °)
20. Install the large and small springs and the O-ring.
IMPORTANT
• Apply grease to the O-ring.
(1) Spring, large
(2) Spring, small
Small spring installation position
Install the small springs at position .
(a) Pin hole position
21. Insert the poppet and spring into the cover and mount the plug
loosely (both sides).
IMPORTANT
• Apply hydraulic fluid to the spool.
(1) Poppet
(2) Spring
22. Install the ball bearing and valve plate on the cover.
IMPORTANT
• Take care to face the valve plate correctly.
• Apply grease to the back of the valve plate so it will not fall
off.
(1) Ball bearing
3-S38
HYDRAULIC SYSTEM
RY9212148HYS0137US0
(3) O-ring
RY9212148HYS0138US0
RY9212148HYS0139US0
(3) Plug
RY9212148HYS0140US0
(2) Valve plate
RY9212148HYS0141US0
KiSC issued 08, 2015 A