Kubota KX080-4 Workshop Manual page 354

KX080-4, WSM
(B) (w/attach) Start Point Set
• Make setting when the AUX2 proportional valve, spool and/or AUX2 knob is replaced.
• Mount an attachment on the AUX2 port and make the setting.
(C) (w/o attach) Start Point Set
• Make setting when the AUX2 proportional valve, spool and/or AUX2 knob is replaced.
• Use this setting method when an attachment is not available.
(D) Feeling Adj.
• Adjust the AUX2 start point to customer's specification.
1. Select Setting → AUX2/Thumb Set → (w/attach) Start Point
Set.
2. Follow the instructions on the meter panel.
3. Press SW5 to make the setting.
4. Follow the instructions on the meter panel and repeat steps 2
and 3.
[Work flow]
Accel to MAX → Measure L when attachment moves →
Measure R when attachment moves
1. Place the mini excavator on flat hard ground, lower the bucket
and the blade, and stop the engine.
2. Follow the chapter Releasing Pressure in the Hydraulic System
and release pressure in the hydraulic line.
3. Attach a pressure gauge at the end of the AUX2 discharge (high
pressure side, low pressure side).
4. Select Setting → AUX2/Thumb Set → (w/o attach) Start Point
Set.
5. Follow the instructions on the meter panel.
6. Press SW5 to make the setting.
7. Follow the instructions on the meter panel and repeat steps 2
and 3.
[Work flow]
Accel to MAX → Measure L when pressure rises → Measure R
when pressure rises
1. Select Setting → AUX2/Thumb Set → Feeling Adj.
2. Follow the instructions on the meter panel and change the
number while monitoring the feel.
3. Press SW5 to make the setting.
CAUTION
• Only use when it does not work properly even after making
the start point setting.
(1) Right fine adjustment value
4-S23
ELECTRICAL SYSTEM
RY9212148ELS0039US0
RY9212148ELS0040US0
(2) Left fine adjustment value
RY9212148ELS0041US0
KiSC issued 08, 2015 A