Kubota KX080-4 Workshop Manual page 397

KX080-4, WSM
2. Continuity check
[Measurement Conditions]
1. Key switch: OFF
2. Disconnect the connector to be tested.
3. Test the continuity based on the table below.
Mea-
sure- Connector Name (+ terminal side)
ment
(1) 5A fuse
(2) Lever lock switch connector
(3) Lever lock switch
(4) Main ECU
(5) Main (solenoid)
(6) Main (solenoid)
Regular: Continuity
Irregular: No continuity
[D] Testing the Equipment Itself
[E] Steps to Take after Completing Repairs
Pin No. Connector Name (- terminal side)
– Lever lock switch
<1> Engine (solenoid)
<1> Main ECU
<62> Engine (solenoid)
<8> Lever lock solenoid
<12> Lever lock solenoid
1. Inspecting the lever lock switch
[Test Conditions]
1. Key switch: OFF
2. Disconnect the lever lock switch connector from the machine
and press the switch and check for continuity.
Regular: Continuity
Irregular: No continuity
(a) Lever lock switch
(b) Lever lock switch Connector
2. Testing the lever lock solenoid
[Test Conditions]
1. Key switch : OFF
2. Disconnect lever lock solenoid connector from the machine and
test the solenoid separately.
Lever lock solenoid Factory specification
(a) Lever Lock Solenoid Terminals
1. Delete failure record
1. While in the service/dealer mode, select Delete Fail Record and
delete the record.
2. After deleting the record, start the engine again and check to
make sure the warning is not shown on the meter panel.
(1) No Fail Record
4-S66
ELECTRICAL SYSTEM
Pin No.
<2>
<8>
<67>
<12>
<1>
<2>
RY9212148ELS0157US0
(c) Lever lock switch Connector
terminals
RY9212148ELS0094US0
12 Ω ±10 %
RY9212148ELS0095US0
RY9212148ELS0148US0
KiSC issued 08, 2015 A