Kubota KX080-4 Workshop Manual page 31

KX080-4, WSM
Installing and Removing Quick Couplings
• To remove a quick hose coupling, push the fitting in the direction
of the arrow and pull on the plastic part in the opposite direction.
• To attach a quick coupler, push it in firmly in the direction of the
arrow. Then check that it will not pull off.
(1) Plastic Part
Connecting the face sealing (ORS) type hose
1. Remove the protective cap from the adapter and make sure the
O-ring is installed in its groove. (If the O-ring is missing, fit the
specified-size in position.)
2. Shift the hose's cap nut in the direction of arrow until the O-ring
contact face stretched out of the cap nut.
3. Bring the hose's O-ring contact face in close contact with the
joint's O-ring.
Make sure they do not come off each other.
4. Tighten up the cap nut to the specified torque.
(1) Protective cap
G-10
GENERAL
(2) Fitting
RY9212001GEG0022US0
RY9212038GEG0005US0
KiSC issued 08, 2015 A