Kubota KX080-4 Workshop Manual page 395

KX080-4, WSM
[B] Inspecting each Device Visually and Physically
3. Tester mode
1. Select the tester mode.
2. Start the engine.
3. Put the machinery operation lever lock in the [Unlock] position.
4. Operate the lever lock switch and lever lock solenoid and check
the switch according to the following table.
Regu-
lar
Lever lock
switch ON
Lever lock
switch OFF
Lever lock
solenoid ON
Lever lock
solenoid OFF
(1) 2 Speed SW
2 Speed SOL
Lever Lock SW
Lever Lock SOL
Hydoil
1. Checking fuses
1. Check whether the 5A lever lock fuse is blown.
2. Causes when a break in wiring
[Test Conditions]
1. Key switch : OFF
2. The lever lock switch connector is disconnected.
3. The lever lock solenoid connector is disconnected.
4. There is a break somewhere in the wiring.
Pull on the harness and make sure the connector/harness does
not come off. (pull with a max of 3 kgf (30 N, 7 lbf) of force) If it
comes off, plug the connector back in securely and check the lever
lock switch and lever lock solenoid in the tester mode.
(a) Lever Lock Solenoid Connector
4-S64
ELECTRICAL SYSTEM
Warn- Warn-
When
ing ing
cut off
lamp lamp
Off Off
Off Off
Off Off
Off Off
(c) Unlock
(d) Lock
(e) Machinery Operation Lever Lock
RY9212148ELS0091US0
RY9212001ELS0088US0
(b) Lever Lock Switch Connector
RY9212148ELS0092US0
When Warn-
shorte ing
d lamp
Off
Off
Off
Off
KiSC issued 08, 2015 A