Kubota KX080-4 Workshop Manual page 416

KX080-4, WSM
2. Continuity check
[Measurement Conditions]
1. Key switch: OFF
2. Disconnect the connector to be tested.
3. Test the continuity based on the table below.
Mea-
sure- Connector Name (+ terminal side)
ment
(1) Anti-theft connector
(2) Anti-theft connector
(3) Anti-theft connector
(4) Anti-theft connector
(5) Anti-theft connector
Regular: Continuity
Irregular: No continuity
[D] Testing the Equipment Itself
[E] Steps to Take after Completing Repairs
Pin No. Connector Name (- terminal side)
<1> Main ECU connector
<3> Main ECU connector
<4> Main ECU connector
<5> Main ECU connector
<6> Main ECU connector
1. Inspecting the anti-theft antenna
[Measurement Conditions]
1. Key switch : OFF
2. Replace with a new antenna.
3. Select the tester mode and check the anti-theft antenna.
1. Delete failure record
1. While in the service/dealer mode, select Delete Fail Record and
delete the record.
2. After deleting the record, start the engine again and check to
make sure the warning is not shown on the meter panel.
(1) No Fail Record
4-S85
ELECTRICAL SYSTEM
Pin No.
<49>
<37>
<51>
<41>
<59>
RY9212148ELS0123US0
RY9212001ELS0205US0
RY9212148ELS0148US0
KiSC issued 08, 2015 A