Installing The Front Glass - Kubota KX080-4 Workshop Manual

KX080-4, WSM

[7] INSTALLING THE FRONT GLASS

9. Use suction pads to install the sash.
10. Use tape or the like to hold it in place until the adhesive hardens.
IMPORTANT
• Take care not to drop the glass.
• After installation, leave to cure for at least 24 hours.
1. Use the scraper and the cleaning agent to remove any
remaining adhesive, grime or oil on the front frame and then
apply the trim to the frame.
CAUTION
• Take care not to cut your hands or fingers on the blade of
the scraper.
• Take care not to get the cleaner or the primer in your eyes.
(1) Front Frame
2. Apply primer and allow to dry for the indicated time.
15°C or higher
Ambient
temperature
Below 15°C
(a) No less than 12 mm (0.47 in.)
3. Apply the adhesive only to the bottom of the front frame (round
frame).
4. Use suction pads to mount the front glass to the frame.
IMPORTANT
• Take care not to drop the glass.
(1) Adhesive (Sikaflex - 265)
(2) Nozzle
(3) Trim
5-S48
RY9212148CAS0060US0
(2) Trim
RY9212148CAS0061US0
10 minutes
30 minutes
RY9212148CAS0062US0
(a) No less than 8 mm (0.31 in.)
(b) No less than 12 mm (0.47 in.)
RY9212148CAS0063US0
KiSC issued 08, 2015 A
CABIN