Kubota KX080-4 Workshop Manual page 213

KX080-4, WSM
9. Remove the parallel pin.
• Tool to use: Magnet
IMPORTANT
• If the parallel pin will not come out using a magnet, use the
following procedure.
Drill a hole in the parallel pin and cut threads in the hole.
• Tool to use: 4.2mm drill bit, M5 tap
IMPORTANT
• Be careful not to scratch the flange holder.
(1) Parallel pin
10. Remove the ring nut.
• Tool to use: Ring nut socket
IMPORTANT
• Be careful that the ring nut socket doesn't come off during
installation/removal.
(b) Ring nut socket
11. Use removal bolts to raise the gear case up higher than the
flange holder and remove the gear case.
• Tool to use: removal bolts
IMPORTANT
• Tighten the removal bolts equally.
(1) Gear case
(2) Flange holder
12. Remove the floating seal from the flange holder side.
• Tool to use: Slotted screwdriver
(1) Floating seal
3-S54
HYDRAULIC SYSTEM
RY9212158HYS0049US0
RY9212158HYS0005US0
(c) Removal bolts
RY9212148HYS0023US0
RY9212148HYS0024US0
KiSC issued 08, 2015 A