Kubota KX080-4 Workshop Manual page 195

KX080-4, WSM
12. Install the plate and O-ring.
IMPORTANT
• Apply grease to the O-ring.
(1) Plate
When parts inside the gear case have been replaced, take
measurement C between the inner race and the housing and then
select the correct plate.
• Tool to use: depth gauge
[Measurement Method]
Measurement A (Photo a) - measurement B (Photo b) =
measurement C
• Housing height: measurement A (Photo a)
• Height between inner race and highest point of housing:
measurement B (Photo b)
Less than
Measure-
5.3 to 5.8mm
ment C
(0.21 to 0.23 in.)
Plate to use 2.8 mm (0.11 in.)
13. Install the housing.
Tightening torque Hex socket bolt
• Tool to use: 12 mm hex socket
(1) Housing
14. Tap the ball bearing in and install the shaft.
IMPORTANT
• Face the ball bearing so the inscription is up.
• Apply grease to the circumference of the ball bearing.
(1) Ball bearing
3-S36
HYDRAULIC SYSTEM
(2) O-ring
RY9212148HYS0128US0
Less than
6.5 to 7.0 mm
5.3 to 5.8mm
(0.26 to 0.28 in.)
(0.21 to 0.23 in.)
2.3 mm (0.09 in.) 1.8 mm (0.07 in.)
RY9212148HYS0148US0
177.0 ± 10.0 N·m
18.0 ± 1.0 kgf·m
130.5 ± 7.5 lbf·ft
RY9212148HYS0130US0
(2) Shaft
RY9212148HYS0131US0
KiSC issued 08, 2015 A