Kubota KX080-4 Workshop Manual page 428

KX080-4, WSM
4. Continuity check (AUX1/AUX2 switch)
[Measurement Conditions]
1. Key switch: OFF
2. Disconnect the connector to be tested.
3. Test the continuity based on the table below.
Mea-
sure- Connector Name (+ terminal side)
ment
(1) Right control lever
(2) Right control lever
(3) Right control lever
(4) Left control lever
(5) Left control lever
(6) Left control lever
Regular: Continuity
Irregular: No continuity
Solenoid side
(a) Main ECU connector
(b) Engine (solenoid)
connector
(c) Main (solenoid) connector
• If connectors (c) (d) are removed, the engine will start but the machine will not operate.
Pin No.
<3>
<1>
<2>
<3>
<1>
<2>
(d) AUX1 (R) solenoid
connector
(e) AUX1 (L) solenoid
connector
Connector Name (- terminal side)
Main ECU
Main ECU
Main ECU
Main ECU
Main ECU
Main ECU
(f) AUX2 (R) solenoid
connector
4-S97
ELECTRICAL SYSTEM
Pin No.
<28>
<11>
<10>
<29>
<11>
<10>
RY9212148ELS0190US0
(g) AUX2 (L) solenoid
connector
RY9212148ELS0191US0
KiSC issued 08, 2015 A