Kubota KX080-4 Workshop Manual page 410

Hide thumbs Also See for KX080-4:

Table of Contents

KX080-4, WSM

[D] Testing the Equipment Itself

[E] Steps to Take after Completing Repairs

1. Testing the AI pressure switch

[Test Conditions]

1. Key switch: OFF

2. Disconnect the AI pressure switch connector from the control

valve and attach the tester.

3. Start the engine and check continuity when it is operating and

when not operating.

When operating: No continuity

When not operating: Continuity

The AI switch is normally closed (normally ON)

2. Settings after replacing device

1. Make AI settings.

AUX2/Thumb Set

1. Delete failure record

1. While in the service/dealer mode, select Delete Fail Record and

delete the record.

2. After deleting the record, start the engine again and check to

make sure the warning is not shown on the meter panel.

(1) No Fail Record

ELECTRICAL SYSTEM

RY9212148ELS0173US0

RY9212148ELS0205US0

RY9212148ELS0148US0

KiSC issued 08, 2015 A

Chapters

Table of Contents