Kubota KX080-4 Workshop Manual page 174

KX080-4, WSM
15. Install the O-rings.
IMPORTANT
• Take care not to scratch the surface of the port.
(1) O-Ring
16. Install the L/S regulator.
• Tool to use: 5 mm hex socket
Tightening torque Socket head bolt (2)
(1) L/S Regulator
17. Adjust the L/S regulator to the measurement prior to
disassembly.
• Tool to use: ruler, 13, 24 mm wrench
(1) Nut
18. Install the needle bearing and the collar.
IMPORTANT
• Install so the machined surface of the collar is facing the
needle bearing.
(1) Needle Bearing
19. Install the valve plate, spool guide and the piston.
• Tool to use: ruler, 24 mm wrench
IMPORTANT
• Position so the notch is aligned with the pin.
• Apply hydraulic oil to both faces of the valve plate.
Tightening torque Spool guide (2)
(1) Valve Plate
(2) Spool Guide
3-S15
HYDRAULIC SYSTEM
RY9212148HYS0422US0
12.65 N·m
1.29 kgf·m
9.93 lbf·ft
(2) Hex Socket Bolt M6 x 15 x 4
RY9212148HYS0423US0
(2) Set Screw
RY9212148HYS0424US0
(2) Collar
RY9212148HYS0425US0
51.0 N·m
5.20 kgf·m
37.6 lbf·ft
(3) Piston
RY9212148HYS0426US0
KiSC issued 08, 2015 A