Table of Contents
Advertisement
Installation
1.
Fit the throttle twist-grip assembly then locate the
handlebars in the lower halves of the clamp. Fit the
clamp and bolts together with the instruments.
2.
Align the handlebar punch mark with the lower-rear
inner left hand split line of the clamp.
3.
Models up to VIN 241569:
Tighten the front
clamp bolts to
26 Nm,
then the rears.
4.
Models from VIN 241570:
Tighten the front
clamp bolts to
45 Nm,
then the rears.
l
J
I J
1.
Clamp split line
2.
Handlebar punch mark
5.
Models up to VIN 241569:
Pivot the instruments
into position then fit and tighten the cover bolts to
3Nm.
6.
Models from VIN 241570:
Position the instrument
and bracket assembly to the handlebar clamp and
secure with the two screws. Tighten the screws to
9Nm.
Z
Fit the chrome cover to the instrument bracket.
8.
Locate the clutch lever assembly to the handlebar
and fit the clamp.
Frame and Bodywork
9.
Align the clamp lower split line with the punch mark
on the handlebar then tighten the clamp bolts to
15Nm.
2
/
e
1.
Clamp lower split line
2.
Handlebar dot mark
10. Fit the clamp to the front brake master cylinder.
11. Align the clamp lower split line with the punch mark
on the handlebar then evenly tighten the clamp bolts
to
15 Nm.
1.
Clamp lower split line
2.
Handlebar dot mark
12. Refit the left hand switchgear assembly, tightening
the screws to
3 Nm.
13. Refit the right hand switchgear assembly, tightening
the screws to
3 Nm.
SelVice Manual - Rocket Ill/ Classic / Touring
17.33
Advertisement
Chapters
Table of Contents
