Assembly; Installation - Triumph Rocket III Classic Service Manual

Brakes
2. Check that the relief and supply ports on the cylinder
are not blocked.
1. Ports
Assembly
Never use mineral based grease in any part of the
braking system or in any area where contact with the
braking system is possible. Mineral based grease will
damage the hydraulic seals in the calipers and master
cylinders. A dangerous riding condition leading to loss
of motorcycle control and an accident could result if this
warning is ignored.
1. Lubricate the piston and cylinder with new, clean
brake fluid.
Ensure that the piston and piston seal are fitted facing
the same way as noted during removal. A dangerous
riding condition leading to loss of motorcycle control
and an accident could result from incorrect assembly of
the master cylinder.
2. Fit the new piston set into the master cylinder and
retain with a new circlip.
cbzn
1.
Piston
2.
Seal (in correct orientation)
3. Refit the master cylinder dust cover.
Installation
1. Locate the master cylinder to the handlebars.
2. Position the clamp to the rear side of the handlebars.
3. Align the master cylinder/clamp split line with the
dot mark on the underside of the handlebar.
1.
Split line
2.
Dot mark
4. Tighten the clamp bolts, upper first and then the
lower to 15 Nm.
15.22
SelVice Manual- Rocket 1111 Classic
1
Touring