Removal - Triumph Rocket III Classic Service Manual

All Models
1Z Refit the non-return valve to the scavenge oil pump.
19. Refit the sump (see page 9-12>.
20. Refit the torsional damper (see page
8-
m.
21. Refit the oil pump drive and pressure pump (see
page 9-14>.
22. Refit the alternator (see page 18-23>.
23. Refit the starter motor (see page
18-25>.
24. Refit the camshaft drive chain (see page 3-11>.
25. Refit the clutch (see page 4-10>.
26. Refit engine to the frame (see page 10-5>.
Crankshaft
Crankshaft
Removal
1. Remove the engine from the frame (see page
10-2>.
2. Separate the lower and upper crankcases (see page
5-5>.
3. Lift the balancer shaft out of the upper crankcase.
cM
Removing the Balancer Shaft
4. Remove the connecting rod big end caps (see page
5-12>.
Discard the bolts after removal.
5. Lift the crankshaft from the upper crankcase.
Support the connecting rods during crankshaft
removal to prevent damage to the rods, liners and
upper crankcase.
Removing the Crankshaft
SelVice Manual - Rocket '" I Classic I Touring
5.11