Alternator; Removal - Triumph Rocket III Classic Service Manual

Electrical System
Alternator
Removal
1. Remove the seat (see page 17-17 for Rocket III and
Classic, see page 17-18 for Rocket III Touring>.
2. Disconnect the battery, negative (black) lead first.
3. Remove the engine (see page
10-2>.
4. Release the bolts securing the starter motor to the
alternator cover.
1. Starter motor
2. Starter motor fixings
3. ~ternatorcover
5. Release the bolts securing the alternator cover to the
rear of the engine.
6. Withdraw the alternator cover from the crankcase.
Note:
• To use tool T3880201, insert the tool pegs into
a pair of rotor holes. However, tool T3880201
will not engage with every pair of holes in the
rotor. The holes are offset and so the tool will
only engage with certain pairs of holes.
Z To remove the rotor, prevent the crankshaft from
rotating using tool T3880201, and remove the centre
bolt and washer from the end of the crankshaft.
1. Rotor
2. Rotor bolt
3. Tool T3880201
8. Screw tool T3880200 into the rotor centre.
9. Prevent the rotor from turning using tool T3880201
while tightening tool T3880200. This will release the
taper seating of the rotor to the crankshaft.
cbtJq
1. Rotor
2. Tool T3880200
3. Tool T3880201
10. Withdraw the rotor and tool as an assembly and then
separate the tool from the rotor.
Note:
• If removing the stator, make a note of the
cable routing before removing the cable
retainer.
18.22
SelVice Manual - Rocket III I Classic I Touring