Friction Plate Inspection; Thickness - Triumph Rocket III Classic Service Manual

Z Remove the centre nut, Belleville washer, plain
washer, clutch inner drum and thrust washer.
1.
Centre nut
2. Belleville washer
3. Plain washer
4. Inner drum
5. Thrust washer
8.
Discard the Belleville washer and the plain washer.
9.
Slide the clutch outer drum outwards from the
engine, collecting the bearing sleeve on removal of
the drum.
1.
Outer drum
2. Bearing sleeve
Clutch
Friction Plate Inspection
Thickness
1. If any friction plate thickness is outside the service
limit, replace the friction plates as a set.
cbvy
1.
Clutch friction plate
Friction plate thickness - all plates
Standard
3.72 - 3.88
mm
Service limit
3.5
mm
2.
Check all plates for bend and warp as follows: Place
the plate being checked on a clean surface plate and
attempt to pass a feeler gauge of the maximum
service limit thickness between the friction plate and
surface plate. If the feeler gauge can be passed
beneath the friction plate at any point, renew the
plates as a set.
cbvz
1. Friction plate
2. Feeler gauge
3. Surface plate
Friction plate bend/warp
Service limit
I
0.30
mm
SelVice Manual - Rocket 1111 Classic 1 Touring
4.9