Triumph Rocket III Classic Service Manual page 386

Fuel System/Engine Management
Examination
1.
Check that the throttle cables operate smoothly,
without sticking or binding. Replace the cable if there
is any doubt as to its correct operation.
Installation
Note:
• The opening and closing cables must be
correctly identified and fitted to the correct
positions as noted prior to removal.
1.
Locate the cables to the frame following the routing
noted during removal.
2.
Engage the nipples of the inner cables to the twist
grip.
Note:
• Rocket III and Classic continue from step 3 to
step 9. Then continue from step 12 to step 18.
• Rocket III Touring continue from step 10 to
step 18.
Rocket III and Classic
3.
Locate the master cylinder to the handlebars.
4.
Position the clamp to the rear side of the handlebars.
5.
Align the master cylinder/clamp split line with the
dot mark on the underside of the handlebar.
o
1. Split line
2.
Dot mark
6. Tighten the master cylinder clamp bolts, upper first
and then the lower to 15 Nm.
Z Assemble the switch cube to the master cylinder,
tightening the two screws to 3 Nm.
8. Attach the cable retainer screw and union to the
master cylinder, tightening both to 3 Nm.
1
1.
Throttle cables
2. Retainer screw
3.
Union
9.
For Rocket
III
and Classic, continue from step
12.
Rocket III Touring
10. Assemble the switch cube, tightening the two screws
to
3
Nm.
11. Attach the cable retainer screw and union to the
switch cube, tightening both to
3
Nm.
All Models
12.
Attach the other end of the inner cables to the
throttle cam and locate the outer cables to the cable
bracket. Ensure the opening and closing cables are
located to the correct cams then fit the cable
locknuts and tighten to 8 Nm.
11.182
SelVice Manual - Rocket III / Classic / Touring
(