Table of Contents
Advertisement
Fuel System/Engine Management
2.
Refit the pump clamp and tighten a new screw to
2Nm.
1
3
"""
1. Fuel pump
2. Fuel pump clamp
3. Mounting bar
3.
locate the fuel pipe and hose to the pump outlet.
4.
Making sure that the anti·rotation tab is located in its
slot, align the fuel pipe and fuel level sender to the
screw hole in the mounting bar. Fit a new screw and
tighten it to 10 Nm.
5.
Position the hose clip on the fuel pipe to the outlet
spigot on the pump.
6.
Refit/replace the filter (arrow pointing away from the
pump) by engaging it with the hose on the fuel pipe.
"'"
1. Filter
2. Clip
3. Inlet hose
4. Filter arrow
Z
Position the hose clip to the filter inlet.
8.
Refit the pressure regulator and hoses to the filter
and pump plate. Engage the hoses with the filter
outlet and pump plate.
9.
Secure the regulator to the mounting bar with a new
screw, tightening it to 10 Nm.
10. Position the hose clips to the filter outlet and pump
plate.
11. Reconnect the two electrical connections to the
pump plate, in the positions noted/marked prior to
removal.
-
1 . Fuel pump
2. Electrical connection
12. Check that the fuel level sender arm moves freely
along its full range of travel, and comes to rest on the
pump plate. Rectify as necessary.
Installation
1.
Position a new a·ring seal to the fuel tank opening.
2.
Refit the fuel pump assembly to the tank. Fit and
tighten the nuts to 5 Nm working on diagonally
opposite nuts to spread the clamping load evenly.
3.
Refit the fuel tank (see page 11-
ISOl.
11.158
Service Manual - Rocket Ill/ Classic / Touring
Advertisement
Chapters
Table of Contents
