Triumph Rocket III Classic Service Manual page 406

Fuel System/Engine Management
10. Remove the lower heat shield from the headers.
After removal, collect the small rubber isolators from
the brackets on the inner heat shield (or on a tag on
the end of the upper shields, depending on where
they are retained).
3
W
e/-
-
1 . Inner heat shield
2.
Isolator brackets
3. Isolators
4.
Upper heat shields
11.
Release the clamp securing the headers to the
catalyst box.
12. At the cylinder head, release the nuts securing the
header pipes to the head.
---I)
\\~
"=:
11
1. Header downpipe
2.
Fixlngs
13. Detach and remove the header assembly.
14. Collect the header gaskets from the head and
catalyst box entf)'.
Note:
• The catalyst box is secured to the frame by a
single fixing on the right hand side, and is
IDeated on two studs on the left hand side.
The catalyst box is located vef)' close to the starter
cables. Ensure you have disconnected the battef)'.
Otherwise an electrical short may occur.
15. Release the fixing securing the catalyst box to the
frame.
1. Catalyst box
2.
fixing
16. Detach the catalyst box by easing it to the right hand
side of the motorcycle.
Note:
• Catalyst box mounting grommets may remain
in the eatalyst box or may adhere to the
mounting studs on removal of the catalyst box.
lZ Collect the catalyst box mounting grommets.
11.202
SelVice Manual - Rocket Ill/ Classic / Touring
(
(
(