Bearing; Circlip - Triumph Rocket III Classic Service Manual

12. Fit the shouldered splined bush (11) to the output
shaft. For the correct orientation of the shouldered
splined bush see the illustration on page
8-24.
13. Slide third gear (10) onto the shouldered splined
bush.
14. Fit the shouldered splined bush (8) in to the third
gear (9), then fit to the output shaft. For the correct
orientation of the shouldered splined bushes see the
illustration on page 8-24.
15. Fit a new circlip
(7),
orientating the circlip as shown
below.
1. Third/fourth gear
2. Circlip
Transmission
16. Fit fifth gear (6) to the shaft, followed by the thrust
washer (5).
1Z To complete assembly of the output shaft, fit the
needle roller bearing (4), first gear
(3),
thrust washer
(2)
and bearing (1).
SelVice Manual - Rocket Ill/ Classic / Touring
8.27