Table of Contents
Advertisement
Frame and Bodywork
To refit the rear seat, position it to the rear mudguard and
tighten the three fixings to 9
Nm.
Refit the rider's seat.
Rocket III Classic only:
1. Seat tongue
2. Centre bayonet
3. Rear lock
4. Rear bayonet
Note:
•
An audible click can be heard when the
bayonets have engaged into the locks.
1.
Position the seat to the motorcycle and engage the
tongue at the front edge of the seat beneath the fuel
tank bridge.
2.
Align the centre and rear bayonets, pressing home
the bayonet to the rear lock first.
3.
Press down in the middle of the seat to engage the
bayonet to the centre lock.
4.
Grasp the seat and pull upwards to check the seats
security.
To prevent detachment of the seat during riding, after
fitting always grasp the seat and pull firmly upwards. If
the seat is not correctly secured in the lock it will detach
from the rear frame. A loose or detached seat could
cause loss of motorcycle control and an accident.
Seat - Rocket III Touring
1. Rear Fixing and Reflector
2. Side Fixing5
1.
To remove the seat, remove the rear fixing, with the
reflector, and the two side fixings. Lift the seat up at
the back for complete removal from the motorcycle.
2.
To refit the seat, engage the seat's tongue under the
fuel tank, fit and tighten the side fixings to
20 Nm.
3.
Fit the rear fixing, with the reflector, and tighten to
9Nm.
To prevent detachment of the seat during riding, after
fitting always grasp the seat and pull firmly upwards. A
loose or detached seat could cause loss of motorcycle
control and an accident.
17.18
SelVice Manual- Rocket Ill/ Classic / Touring
Advertisement
Chapters
Table of Contents
