Side Covers; Removal; Installation - Triumph Rocket III Classic Service Manual

Side Covers
Removal
Before starting work, ensure the motorcycle is stabilised
and adequately supported. This will help prevent it from
falling and causing injury to the operator or damage to
the motorcycle.
Rocket III and Classic
1.
Remove the seat (see page 17-
17).
2. Raise the tool kit.
3. Release the two screws securing each side cover to
the frame.
1.
Screws
2. Side covers
Note:
• During removal of the right hand side cover,
disengage the seat lock from the rear of the
cover.
4. Raise each side cover until clear of the mounting
posts. The covers may then be removed from the
motorcycle.
Frame and Bodywork
Rocket III Touring
1. Lower the passenger footboards.
2. Pull the top of the side cover to detach the two upper
mounting bayonets.
1.
Side cover upper mounting bayonets
2. Lower mounting post
3. Raise each side cover until clear of the mounting
posts. The covers may then be removed from the
motorcycle.
Installation
Note:
• Ensure that the mounting post grommets are
correctly installed in the cover bases.
Rocket III and Classic
4. Install the covers to their mounting posts ensuring
the grommets are not displaced. Ensure that the
right hand cover engages correctly over the seat
lock.
5. Fit and tighten the cover screws to
9 Nm.
6. Pivot the tool kit into place.
Z Refit the seat (see page 17-
17).
Rocket III Touring
8. Install the covers to their mounting posts ensuring
the grommets are not displaced.
9. Align the upper mounting bayonets to their
mountings on the frame.
10. Press on the upper mounting bayonets to engage
them into their mountings.
SelVice Manual - Rocket III I Classic I Touring
17.19