Triumph Rocket III Classic Service Manual page 469

Front Fork - Rocket III Touring
Removal
Before starting work, ensure the motorcycle is stabilised
and adequately supported. This will help prevent it from
falling and causing injury to the operator or damage to
the motorcycle.
1. Raise and support the front of the motorcycle.
2.
Remove the seat (see page 17-18).
3. Disconnect the battery, negative (black) lead first.
4.
Remove the windscreen (see page 17-30>.
5.
Remove the front wheel (see page 16-10>.
6.
Remove the front mudguard (see page 17-24).
Z the instrument
1.
Instrument assembly fixings
8. Protect the top of the fuel tank from accidental
damage and position the instrument assembly clear
of the top yoke.
Note:
• If the forks are to be dismantled, slacken the
fork top cap (at the top of the fork> and the
damping cylinder securing bolt (at the bottom
of the fork>. Then lightly tighten the damping
cylinder securing bolt to prevent fluid loss
before releasing the yoke clamps.
Front Suspension
9. Slacken the top yoke clamp bolts.
1. Top yoke clamp bolt
Note:
• Make a note of the cable routings behind the
cable guide.
10. Release the two screws and remove the cable guide.
cosy
~
1.
Cable guide fixings
2. Cable guide
11. Remove the handlebar (see page 17-34).
12. Slacken and remove the top nut and washer.
Lift
and
remove the top yoke.
1
0)
ceta
1. Top nut
SelVice Manual - Rocket III
I
Classic
I
Touring
14.27