Installation - Triumph Rocket III Classic Service Manual

Clutch
Installation
1.
Position the bearing sleeve then the clutch outer
drum to the input shaft.
2.
Align the oil pump drive pegs with the
corresponding holes in the rear of the clutch outer
drum.
1.
Clutch outer drum
2. Oil pump sprocket drive pegs
3. Oil pump drive holes
3. Pre-Ioad and align the primary gear and backlash
eliminator with the crank gear. Align the gears
through the hole arrowed below.
1. Primary gear
2. Backlash eliminator
3. Crank gear
4. Arrowed: alignment hole
Note:
• When the outer drum is correctly fitted and the
gears are pre-Ioaded correctly, the bearing
sleeve will be a flush fit with the clutch drum
face. In addition, a groove around the input
shaft will be visible.
4. Fit the thrust washer to the shaft.
1.
Thrust washer
5.
Fit the clutch inner drum.
6.
Fit a new plain washer, fit a new Belleville washer
('OUT'
mark facing outwards), and refit the centre
nut.
1. Belleville washer
'our
mark
4.10
SelVice Manual- Rocket Ill/ Classic / Touring