Triumph Rocket III Classic Service Manual page 201

Installation
Note:
• As the frame is being lowered onto the engine,
reconnect the low oil pressure warning light
switch and attach the breather hose.
1. Locate the frame to the engine aligning the engine
mounting points with the corresponding positions on
the frame.
2. Install the engine mounting bolts and nuts, but do
not tighten any yet.
1. Lower rear mounting bolt (one per side)
2. Upper rear mounting bolt (one per side)
3. Front mounting bolt
3. Tighten the engine mounting bolts, nuts, adjusters
and adjuster collars in the following sequence:
Support the frame and engine, and temporarily
remove the rear right hand mounting bolts.
Tighten both right hand engine mounting
adjusters to 5 Nm.
Using service tool T3880063, tighten the
locking collars on both right hand engine
mounting adjusters to 55 Nm.
Refit the rear right hand mounting bolts.
Tighten the upper and lower left hand rear
engine mounting bolts and nuts to 80 Nm.
Tighten the upper and lower rear right hand
engine mountings to 80 Nm.
Tighten the front engine mounting bolt and nut
to 80 Nm.
Engine Removal and Refit
4. Reconnect the remaining electrical connections to
the engine. These include:
Low oil pressure warning light switch
Crankshaft position sensor
Gear position sensor
Road speed sensor
Coolant temperature sensor
Battery earth
Starter motor connections
S.
Attach and secure the engine breather hose with its
clip.
6. Position the airbox to its mountings, fit and tighten its
bolts to 9 Nm.
Z Refit the side stand, tightening the fixings to 40 Nm.
8. Reconnect the side stand switch.
9.
Reconnect the spark plug leads.
10. Position the left hand footrest mounting bar to the
frame and engine.
Note:
• Rocket III shown, Rocket III Classic and Touring
are similar.
11. Fit and tighten the bar's mounting fixings to 27 Nm.
1
cbue
1. Left hand footrest mounting bar
2. Fixings
SelVice Manual - Rocket Ill/ Classic / Touring
10.5