Triumph Rocket III Classic Service Manual page 367

(
(
14. Refit the batHe hose to the fuel pressure regulator
and mounting bar.
.,..,
1. Hose clip
2. Clips
3. Baffle hose
Installation
1. Position a new O-ring seal to the fuel tank opening.
2. Refit the fuel pump assembly to the tank. Fit and
tighten the nuts to 5 Nm working on diagonally
opposite nuts to spread the clamping load evenly.
3. Refit the fuel tank (see page 11-154).
Fuel System/Engine Management
Fuel Level Sensor - Rocket III Touring
Removal
Note:
• The fuel level sensor is located at the front
right hand edge on the underside of the fuel
tank.
1. Remove the fuel tank (see page /1-153).
information section on the safe handling of fuel and fuel
containers.
A fire, causing personal injury and damage to property
could result from spilled fuel or fuel not handled or
stored correctly.
Never drain fuel from the tank using non-approved,
non-professional standard fuel handling equipment. A
fire causing destruction of property and injury to
persons may result from use of non-approved fuel
handling equipment.
2. Using proprietary professional automotive workshop
equipment approved for fuel handling, drain all fuel
from the fuel tank.
3. Invert the fuel tank and place on a protective surface
to prevent paint damage.
4. Disconnect the fuel electrical connector from the
harness.
5. Detach the fuel level sensor harness from the clip
beneath the fuel tank.
SelVice Manual - Rocket 1111 Classic I Touring
11.163