Drive Shaft - Triumph Rocket III Classic Service Manual

Note:
• Before tightening the bevel box nuts, fully
insert the wheel spindle through the swinging
arm to ensure it will realign with the swinging
arm when the wheel is installed.
Note:
• Bevel box to swinging arm fixings are
tightened in two stages and in a specific
sequence. Tighten all fixings to the lower
torque before progressing to the higher figure.
3.
Align the bevel box by fully inserting the wheel
spindle through the bevel box and swinging arm.
4. In the order shown below, tighten all the bevel box
nuts to 20 Nm, then to 64 Nm.
cbv.
Bevel Box Bolt Tightening Sequence
Bevel Box and Drive Shaft
5. Refit the left hand rear suspension unit (see page 13-
6).
6. Refit the rear wheel (see page 16-14) for Rocket III
and Classic, see page 16-17 for Rocket III Touring).
Z Lower the motorcycle to the ground and park it on
the side stand.
8. Check and top up the bevel box oil level (see page
6-3).
Drive Shaft
Drive shaft details can be found in the rear suspension
section on page 13-7.
SelVice Manual- Rocket III I Classic I Touring
6.5