Disassembly - Triumph Rocket III Classic Service Manual

Disassembly
1. Release the three bolts and remove the bearing
retainer plate from the damper shaft housing.
When using a press, always wear overalls, eye, face and
hand protection. Objects such as bearings frequently
break-up under load and the debris caused during
break-up may cause damage and injury to unprotected
parts of the body.
Never wear loose clothing, which could become trapped
in the press and cause crushing injury to the hand, arms
or other parts of the anatomy.
2. Press the shaft assembly from the housing as follows:
Support the housing on press bars as shown
above right.
Failure to support the housing as close as possible to the
bearing outer race, as described below, may result in
damage to the housing.
Ensure the housing is supported as close as
possible to the bearing outer race, but such that
it will allow the bearing to pass through.
Transmission
Press the shaft from the housing, collecting the
shaft as it is released.
1.
Damper shaft housing
2. Press bars
3. Remove and discard the oil seal from the damper
shaft housing.
4. Working from the gear end of the shaft, remove and
discard the circlip.
Remove the collet retaining cap.
6. Remove the two collets.
xlzr ......
1. Collet retaining cap
2. Collets
SelVice Manual - Rocket Ill/ Classic / Touring
8.13